SKU: 91997510735

Seaview 30" Tapered Closed Dome Aft Leaning Radar Mount w/Camera/Searchlight Mount, Removable Spreaders 10x10 Base Plate [PMABC37SV2]

$1221.48 $1357.20
Save 10%
No.2 Bestseller on www.gnsteacherstrainingcollege.org.in >

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 13 - Jul 18

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Seaview 30" Tapered Closed Dome Aft Leaning Radar Mount w/Camera/Searchlight Mount, Removable Spreaders 10x10 Base Plate [PMABC37SV2]30" Tapered Closed Dome Aft Leaning Radar Mount with Camera Searchlight Mount, Removable Spreaders and 10x10 Base Plate The Seaview Tapered Masts are for most 18" to 24" closed dome radars or open array radars up to 4. 5'. Durability Unlike any other mount available, Seaview takes the finish to another level. We take these Tapered Masts in their raw aluminum form through a process called Chem Film. Chem Film is a chemical conversion coating that is

30" Tapered Closed Dome Aft Leaning Radar Mount with Camera/Searchlight Mount, Removable Spreaders and 10x10 Base Plate

The Seaview Tapered Masts are for most 18" to 24" closed dome radars or open array radars up to 4.5'.

Durability

Unlike any other mount available, Seaview takes the finish to another level. We take these Tapered Masts in their raw aluminum form through a process called Chem Film. Chem Film is a chemical conversion coating that is used as a light coat of protective covering over aluminum. After the Chem Film process, it is taken through a 3-part epoxy primer and powder coat. This is all done to ensure the best possible finish and corrosion resistance.

Easy Installation

The lower mounting plate will accept most standard 18" and 24" radar domes or open array radars up to 4.5' in length. No need to drill holes to mount your radar allowing for a quick and easy setup.

Spreaders

Spreaders are fitted with standard 1-14 threaded fittings made out of nylon to eliminate corrosion. Note: do not exceed 4' antennas on spreaders. The spreaders are also removable to keep shipping costs down.

Top Mounting Plate

Feel free to mount a light to the top mounting plate!

Cable Management

Oval hollow mast section allows for easy cable management.

Specifications:

  • Height: 30"
Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 91997510735

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.8 ★★★★★
Based on 1221 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
S
Verified Purchase
Scott Liske
Massapequa, US
★★★★★ 5
Bright
Color: 7*5in Cube LED Pod
Very bright, good quality
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 12, 2026
R
Verified Purchase
Riik
Lexington, US
★★★★★ 5
Easy to install
Color: 4*2.5in Cube LED Pod
Definitely more than I expected. .. dang good product and easy to install
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 11, 2026
R
Verified Purchase
rkruz
Los Angeles, US
★★★★★ 4
Easy Install Onto Jeep JKU, No Switch Backlight or Mounting Holes, Great Customer Service
Color: 5in Cube LED Pod, Color: 5in Cube LED Pod
I installed the Auxbeam 5" 168W LED Cube Pods onto my Jeep JKU Anniversary Steel Bumper. It was an easy install with some YouTube videos to help me snake the cables into the cab. The unused holes in the steel bumper were the perfect size to fit the mounting bolts on the pod lights, and there was plenty of room to reach under the top edge of the bumper to install the nuts with some Loctite. To snake the provided cable through the firewall, I had to remove the installed socket. This was easy to do by simply recessing the retainer clip on each pin, taking a picture of the wired connector before releasing the wires so I knew how to reassemble, snaking the connectorless cable through the firewall into the cab where the pins were then reinserted and locked into the connector. I dressed the cable by zip tie to the existing wire harness at the top of the engine bay. In the cab, I pulled the side panel from the dash (driver's side) and made a small hole for the cable in the panel. After cleaning the dash with alcohol, the adhesive-backed switch seems to hold nicely in place. The lights were very bright and did a great job of illuminating the front and sides of the trail ahead of me. No backlight on the switch, which is a necessity, and I dont understand why that feature is not present. Also, there is no through hole to mount as the adhesive back won't stay attached, so the lack of a mounting hole is a big negative as well. 5 Month UPDATE: One of the lights got water inside. I noticed two screws that hold the glass cover were loose on the bottom of both sides. The other light also had the same loose screws but no water under the glass. I contacted Auxbeam, and they replaced the entire set in 2 days. Very awesome customer service.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 25, 2023
K
Verified Purchase
Kevin Sanguansukdikosol
Bozeman, US
★★★★★ 5
Brightness and quality
Color: 4*2.5in Cube LED Pod
Got this for my 2024 Crosstrek. Got this one specifically due to its functionality that I wanted, quality for the price and it looks great especially DRL. I leave the Amber cover on most of the time. If you want the DRL to be on while the car is on, you can do that but it has to be rewired which I did. Love the brightness. I’ve been having this on my Crosstrek for a few months now and have no issues.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 3, 2026
T
Verified Purchase
Thomas Chapman
Phoenix, US
★★★★★ 5
Bright lights
Color: 4*2.5in Cube LED Pod
Installed these on my Bronco as ditch lights. Very bright light and I like that you can have them be white or put the cover on them for and amber light look. Took about 30 minutes to install and wire to the upfitter switches. They shoot a wide angle covering your blind spots on dark roads. I got these to replace a three inch ditch light. They're made from heavy duty metal and stand up to the extreme weather. I like them so much that I purchased the seven inch lights and install them on the front bumper. For what they cost it was a price that I couldn't pass up. I highly recommend these lights.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 17, 2026

recommand products

King Crimson - Lizard
19.99
Kinks, The - Best Of
26.95
King Gizzard & Lizard Wizard - Chunky Shrapnel
29.98
King, B.B. - Back In the Alley
24.00
King, Carole - Her Greatest Hits
11.99